This guide outlines the procedure to setup server for SOLIDCAM network dongle.
1. In your server computer, run SOLIDCAM Sentinel license manager .bat file.
Note: You may retrieve SOLIDCAM Sentinel license manager by downloading it here.
2. Connect the SOLIDCAM dongle to the server computer.
a. Check to see that the USB light is turned on.
3. In your server computer, install the SOLIDCAM HASP license manager.
Note: You may follow the steps here to install SOLIDCAM HASP license manager.
4. Your server is now successfully setup for SOLIDCAM network dongle.
If you encounter an issue while setup server for SOLIDCAM network dongle, you may contact [email protected] for assistance.
If you found this helpful, we’d love for you to share it!
